Ip Address Setting - FATEK CBEH Manual

1. If you want to use this method to connect a PC and the CBEH in
different domains, then that CBEH's Remote Config. Enabled option
(please refer to the explanations in 3.1.2) must first be checked.
2. When the CBEH module is behind a firewall, you must first open the
firewall's port 111 to perform remote configuration setting.

3.1.2 IP Address Setting

The first step to enter configuration setting is to set the CBEH expansion board's
network, mask and gateway address, which is set on the General function tab as
shown in the figure below:
The following describes the meaning of each field for the user's reference:

IP Assign Mode:
application needs, there are:
1. Static: Static acquisition. User needs to manually set the network, mask and
gateway address.
2. DHCP: Dynamic acquisition. User does not need to set the network, mask
and gateway address; usable address will be acquired through the DHCP
server's status.
3. By PLC: The CBEH module acquires the network address from the PLC's
register (Please refer to the descriptions in Chapter 2).

IP Address: The network address of this expansion board.

Subnet Mask: The subnet mask of this expansion board.

GateWay: The external gateway of the domain where this expansion board is
located.

Host Name: Used for commenting, able to indentify different modules; a
18
Note
IP acquisition mode. Users can set according to their