Chapter 3 Cbeh Basic Configuration Settings; Setting Cbeh Through The Ether_Config Software - FATEK CBEH Manual

Chapter 3 CBEH Basic Configuration Settings

To set CBEH's basic configuration, the user can perform settings through the
Ether_Config software or the system webpage provided by CBEH. The comparison of
the two setting methods are listed in the table below:


Operation
method

Suitable
usage time

Users can refer to the descriptions mentioned in the table above and chose the
suitable method to set the device configuration according to their needs. The
content of this chapter will describe configuration setting methods and the meaning
of each setting fields.

3.1 Setting CBEH through the Ether_Config software

Ether_Config software V3.0 or above along with the FBs-CBEH series module settings
provide the following functions:

Basic module data setting: Contents include network address, gateway address,
network mask, operation mode, module identification name and module
comment etc.

Security setting: Authorized IP (network address) setting; when this function is
used only command messages sent by authorized IP will be accepted by this
15
Ether_Config software
Download v3.0 or above
from FATEK's official website
and install.
Can be connected to CBEH
and perform settings
through scanning the local
area network or specify the
exact IP address.
When you don't know
CBEH's IP address you can
use the Ether_Config
software to scan the local
area network directly.
The user needs to use the
Ether_Config software when
perform the CBEH firmware
updated.
CBEH system webpage

Connect to the webpage by
entering the IP address or
device serial number in the
web browser.

Use CBEH's built-in system
webpage to perform
configuration settings.

If CBEH's IP address setting
matches the currently
connected network
sub-domain and the user
knows this IP or board's
serial number, users can
login to the system
webpage provided by CBEH
through a web browser and
perform configuration
setting directly.