Unison; Ptl Ctrl; Ptl Range - Roland Groovebox MC-707 Reference Manual

OFF
SYNC
RING
XMOD
XMOD2

UNISON

Parameter Value
Unison Switch OFF, ON
Unizon Size 2–8
Unison Detune 0–100

PTL CTRL

Parameter Value
OFF, ON, RANDOM,
Velocity Control
CYCLE
EXP
PMT Level Curve
LINEAR
Partial Switch OFF, ON

PTL RANGE

Level
Fade Lower
Range Lower
Parameter Value
Key Range Low C-–G9
Key Range Up C-–G9
Key Range Fade Low 0–127
Parameter List
Explanation
This layers a single sound.
If the Unison Switch is on, the number
of notes layered on one key will change
according to the number of keys you play.
5 If the OSC Type is PCM, this is limited to
mono playing.
5 If the Legato Switch is on, the Delay Time
is ignored while playing legato.
5 Even if Legato Retrigger Interval is
specified, it operates as OFF.
If unison is on, this specifies the number of
notes that are assigned to each key that is
pressed. Increasing the Unison Size increases
the polyphony, making it more likely that
notes will be cut off.
Detunes each of the notes that are allocated
by the Unison Size number, producing a
detuned effect.
As you increase this value, each note is
detuned more greatly, producing a thicker
sound.
Explanation
Specifies how partials are played according to
your keyboard playing dynamics (velocity)
If this is "ON, " different partials are sounded
according to the playing velocity and the
Velocity Range Lower/Upper and Velocity
Fade Lower/Upper settings
5 If this is "RANDOM"or "CYCLE, " each partial
is sounded randomly or cyclically.
5 In the case of "RANDOM" or "CYCLE" when
Structure 1-2 (3-4) has a setting other than
OFF, partials 1 and 2 (3 and 4) are sounded
as a pair, either randomly or in alternation.
5 In the case of "RANDOM" or "CYCLE, "
velocity has no effect, but you'll need to
make settings for each partial so that the
Velocity Range does not conflict.
When using Velocity Control to switch
between partials, the crossfade level changes
in a non-linear curve.
When using Velocity Control to switch
between partials, the crossfade level changes
in a linear curve.
Use these buttons to turn the partials on/off.
Pitch
Fade Upper
Range Upper
Explanation
Specify the key range for each partial.
Make these settings when you want different
key ranges to play different tones.
Specify the lower limit (Lower) and upper
limit (Upper) of the key range.
Specifies the degree to which the partial
is sounded by notes played below the Key
Range Low. Specify "0" if you don't want such
notes to be sounded.
63