62
Occupant safety
Before every trip, make sure that the ISOFIX
child restraint system or the i‑Size child restraint
system is engaged correctly in both ISOFIX or
i‑Size mounting brackets.
* NOTE Be careful not to damage the seat
belt for the centre seat when fitting the
child restraint system
Make sure that the seat belt is not trap‐
#
ped.
Vehicles with reclining rear seats: before
#
an ISOFIX or i-Size child restraint system is
installed, adjust the reclining rear seat back‐
rest back slightly.
Remove upholstered lining 1.
#
Vehicles without reclining rear seats: fold
#
upholstered lining
1
upwards.
Turn the support on the rear side of uphol‐
#
stered lining
1
by 90°.
Upholstered lining
1
will remain folded
upwards.
Attach the ISOFIX or i‑Size child restraint sys‐
#
tem to both mounting brackets
2
vehicle.
Vehicles with reclining rear seats: return
#
the reclining rear seat backrest to an upright
position.
The reclining rear seat backrest must rest
against the child restraint system.
Securing Top Tether
& WARNING Risk of injury or death from
adjusting the seat after fitting a child
restraint system
Vehicles with electrically adjustable rear
bench seats:
If you adjust the seat after fitting a child
restraint system, the following may occur:
the seat belt may either sit too loose or
R
too tight
the child restraint system can become
R
loose, incorrectly positioned or damaged
in the
As a result, the child restraint system may
not be able to provide the intended level of
protection.