16.3
Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Info
Too little gear oil or poor-quality gear oil results in pre-
mature wear to the transmission.
–
Remove filler plug
Gear oil
–
Mount and tighten oil filler plug.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
V00224-11
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check for tightness.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Remove screw
300661-10
–
Remove filler plug
–
Add gear oil until it flows out of the hole of the gear oil level
plug.
Engine oil (15W/50) (
–
Mount and tighten screw
Guideline
Screw, gear oil level
monitoring
V00224-11
–
Mount and tighten filler plug
SERVICE WORK ON THE ENGINE 16
2
and fill up with gear oil.
0.50 l
Engine oil
(0.53 qt.)
(15W/50)
(
p. 92)
1
.
2
with the O-ring.
p. 108)
1
.
M6
6 Nm (4.4 lbf ft)
2
with the O-ring.
p. 108)
93