Trunk Door - lehman Trikes TRAMP 2009 Service Information

Jump to Flat Rate Times
REMOVAL
1. See Fig. 1. Disconnect license plate light
wiring.
2. See Fig. 1. Depress release tabs on door
hinges and remove hinges from door.
3. See Fig. 2. Remove license plate bracket.
4. See Fig. 3. Remove door latch assembly.
5. Use an electrical pin removal tool to release
pin from socket.
6. Remove license plate light.
7. Remove hinge plate from door.
REPLACEMENT
1. Install new weather seal around new door.
2. Install hinge plate to new door.
3. Install license plate light.
4. Install trunk door latch assembly (see R&R
Trunk Door Latch Assembly).
5. Install license plate bracket to new door.
6. Install new door to hinges. Door will clip into
hinge assembly.
7. Connect license plate light. Test light.
8. Adjust door for proper fitment by closing door
with a strip of paper between door and body in
different locations. Door seals properly if paper
has tension when removed
9. If necessary, adjust door by loosening two Phil-
lips screws located on bottom side of hinges.
Tighten screws when adjustment is complete.
Jump to Parts and Pricing
R & R TRUNK DOOR
36
Fig. 1
Disconnect license plate light wiring
Depress tabs; remove door hinges
Fig. 2
Remove license plate bracket bolts
Fig. 3
Remove door latch assembly