Axle Seal - lehman Trikes TRAMP 2009 Service Information

Powered by suzuki
Table of Contents

Advertisement

Jump to Flat Rate Times
REMOVAL
1. Place trike on lift.
2. Loosen lug nuts with 11/16" shallow socket.
3. Lift trike using a jack under differential carrier
housing and two safety jack stands under left
and right rear axles.
4. Remove lug nuts.
5. Remove left and right rear wheels by sliding
them out and away from body.
6. Remove brake drum.
7. See Fig. 1. Line up holes in axle flange with
retaining nuts and remove all (4) retaining nuts.
NOTE: Axle can be tapped from other side
of flange for removal.
7. Remove axle and backing plate from tube.
8. See Fig. 2. Remove axle seal with puller or
equivalent.
9. Clean area where new seal will be installed.
NOTE: Handle new seal carefully when in-
stalling. Seal can easily become damaged.
10. Set seal into position and secure with proper
seal installation tool.
REPLACEMENT
1. Reinstall backing plate and axle into axle tube.
2. Reinstall axle flange nuts. Torque to 44 ft. lbs.
3. Reinstall brake drums.
4. Reinstall rear wheels.
5. Torque lug nuts to 75 ft. lbs.
CAUTION: Do not over-fill differential. Pos-
sible axle seal failure and contamination of
rear brake linings can occur. Check differ-
ential vent tube to be sure it is free of any
blockage. Blockage can potentially lead to
axle seal failure.
6. Remove differential fill plug and check level of
differential fluid. Apply .9L (30 oz.) of 80w90
gear oil as necessary. Replace fill plug.
7. Torque fill plug to 40 ft-lbs.
Jump to Parts and Pricing
R & R AXLE SEAL
R & R AXLE SEAL
7
Fig. 1
Axle flange retaining nuts
Fig. 2

Axle seal

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for lehman Trikes TRAMP 2009

Table of Contents