Table of Contents
Advertisement
Jump to Flat Rate Times
R & R DIFFERENTIAL CONTINUED
REPLACEMENT
1. See Fig. 5. Support new differential under rear
of motorcycle with jack stands.
2. See Fig. 6. Position differential with pinion
shaft to left of motorcycle centerline and vent
tube pointing upward.
3. Use original mounting hardware to attach dif-
ferential to swingarm.
4. Make sure differential is in the highest possible
position relative to swingarm and drive shaft is
centered to bike.
CAUTION: Driveshaft interference with
swingarm housing may cause equipment
damage or lead to an accident. Verify
proper clearance and adjust as needed.
5. See Fig. 7. Center differential to body using a
framer's square. Adjust differential until equal
measurements are obtained on both sides.
6. Spin drive shaft to check clearance in both
front and rear locations.
7. Torque differential mounting bolts to 47 ft-lbs.
Jump to Parts and Pricing
15
Fig. 5
Support differential with jack stands
Fig. 6
Pinion shaft
Fig. 7
Obtain same measurement
for both sides + or - 1/8"
Vent tube
Hide quick links:
Advertisement
Table of Contents
