Edit Saccades - Interacoustics EyeSeeCam Instructions For Use Manual

Edit Saccades

If you have collected head impulses that have saccades present you can use the Saccade Editor to edit
individual saccades or added saccades that were not identified by the software. You can access the
Saccade Editor from the Report menu, Edit saccades.
Figure 5.1.3-1 Report Menu Edit Saccades
In the Saccade Editor you will see each saccade identified with a green dot. When you select an
individual impulse to review you will see each saccade for that impulse highlighted in gray. The start and
stop of the saccade is marked with the small black lines on either side of the shading. You will see the
latency and peak of each saccade.
Figure 5.1.3-2 Saccade Editor
EyeSeeCam vHIT - Instructions for Use - EN Page 40