Charge Batteries; Two-Bay Battery Charger Base; Ac Power Socket On Imager - Fluke Expert Series User Manual

TiX500, TiX520, TiX560, TiX580
Users Manual

Charge Batteries

Before you use the Imager for the first time, charge the battery for a minimum of two and one-
half hours. The battery status shows on the five-segment charge indicator.
New batteries are not fully charged. Two to ten charge/discharge cycles are
necessary before the battery charges to its maximum capacity.
To charge the battery, use one of the options that follow.

Two-Bay Battery Charger Base

1. Connect the ac power supply to the ac wall outlet and connect the dc output to the charger
base.
2. Put one or two smart batteries into bays of charger base.
3. Charge batteries until charge LEDs on charger base are a solid green.
4. Remove smart batteries and disconnect the power supply when batteries are fully charged.

AC Power Socket on Imager

1. Connect the ac power adapter into an AC wall outlet and connect the dc output to the
Imager's ac power socket.  flashes on the display while the battery charges with the ac
power adapter.
2. Charge until the charge indicator on the display does not flash.
3. Disconnect the ac power adapter when the smart battery is fully charged.
Make sure that the Imager is near room temperature before you connect it to the
charger. See the charging temperature specification. Do not charge in hot or cold
areas. When you charge in extreme temperatures, battery capacity may be
decreased.
 shows in the lower left-hand corner of the display when the Imager is connected to ac
power and the battery is removed. When the power is off on the Imager and the ac power
adapter is connected to the Imager,  flashes in the center of the display to show that the
battery charge is in process.
Keep the Imager attached to the charger until the battery condition icon shows a full charge. If
you remove the Imager from the charger before a full charge shows, it can have a reduced run-
time.
When the battery is connected to ac power or the unit is in video mode, the Sleep
Mode/Auto Off feature is disabled automatically.
48
Shop for Fluke products online at:
Note
Note
Note
MyFlukeStore
www.
1.888.610.7664
.com