WilTec ARTICEL 61197 Operation Manual page 6

Post hole digger
Hide thumbs Also See for ARTICEL 61197:
Table of Contents

Advertisement

o
o
o
If you experience any of the symptoms of this condition immediately stop the use and see your
physician.
Keep the tool well maintained, fasteners tightened and worn parts replaced.
Mix and store fuel in a container approved for fuel.
Mix fuel outdoors where there are no sparks or flames. Wipe up any fuel spillage. Move 9m away
from refueling site before starting engine.
Stop the engine and allow it to cool before refueling or storing the unit.
Allow the engine to cool; empty the fuel tank and secure the unit from moving before transporting
in a vehicle.
SPECIFIC SAFETY RULES FOR POST HOLE DIGGER USE
Replace augers if cracked, bent or damaged in any way. Be sure the auger and or extension shaft
is properly installed and securely fastened. Failure to do so can cause serious injury.
Make sure all guards, straps, deflectors and handles are properly attached.
Do not start working until you have a clear work area. Do not work near electric cables or under-
ground utilities. It is highly recommended that you check with local authorities before starting to
drill.
If auger turns whilst the engine is idling, stop the engine and immediately adjust the idle settings
following the instructions in this manual.
Only use the manufacturer's replacement augers on this unit. Do not use any other attachments.
Never operate until without the safety clutch in working condition. The safety clutch will engage
when the engine is at idle or if a hard object is struck.
Replace the bit immediately if any cracks or other damage are present.
Maintain a firm grip on both handles during operation.
Never use the drill with the handles above waist level. Drilling with the units handles above waist
level restricts control and can cause serious chest injuries if a hard object is struck.
Never carry the power drill with the engine running.
Carry the power drill with the engine stopped and with the auger bit removed.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Keep your body warm in cold weather. When operating the unit wear gloves to
keep the hands and wrists warm. It is reported that cold weather is a major fac-
tor contributing to Raynaud's Syndrome.
After each period of operation you should exercise to increase blood circulation.
Take frequent work breaks. Limit the amount of exposure per day.
Seite 28

Advertisement

Table of Contents
loading

Table of Contents