Advertisement
.
Attach the Track Frame (4) to the Frame (1) with
two M10 x 25mm Patch Screws (48) and two
M10 Split Washers (85). Tip: Finger tighten a
Patch Screw into the lower hole first, and
then finger tighten a Patch Screw into the
upper hole. Then, tighten both Patch Screws.
Tip: This step may be easier if you raise the
Frame (1) a few inches in the location shown
by the arrow at the right while you attach the
Track Frame (4).
See the inset drawing.
Tighten two Leveling
Feet (36) into the underside of the Track Frame
(4).
4
36
85
48
85
.
Apply a small amount of the included grease to
two Wave Washers (88).
Orient a Weld Spacer (89) as shown, and slide it
onto the left Crank Arm (83).
Identify the Left Track Arm (12), which is marked
with a "Left" sticker, and orient it as shown.
Slide the Left Track Arm (12) onto the left Crank
Arm (83). Then, slide a Wave Washer (88) onto
the end of the left Crank Arm.
Repeat this step with the Right Track Arm
(11).
89
Grease
\
11
/
\
\
\
Advertisement
