Advertisement
9.
9
Applya smallamount of grease totwoWave
Washers (88)andtotwoThrust W ashers (66).
SlidetheLeftHandlebar (19)ontothe
Handlebar Axle(16).Then, s lidea Wave
Washer ( 88)ontotheendoftheHandlebar Axle.
StartanM8x 19mm Button Screw(56),anM8
Small W asher ( 18),anAxleCap(41),anda
Thrust W asher ( 66)intotheLeftHandlebar (19).
Make sure that the Thrust Washer remains
on the shoulder
of the Axle Cap, and that the
Wave Washer (88) remains on the end of the
Handlebar Axle (16).
Assemble the Right Handlebar (20) in the same
way.
Tighten both M8 x 19ram Button Screws (58)
at the same time.
16
20
41
_rease
18
10. Apply a small amount of grease to the barrel of
an M8 x 55mm Bolt Set (92) and to two 7mm
Spacers (55).
Have a second person hold the front end of the
Left Pedal Arm (14) inside the bracket on the left
Handlebar Leg (17).
Attach the Left Pedal Arm (14) to the left
Handlebar Leg (17) with the M8 x 55mm Bolt
Set (92), two M8 Washers (69), and the two
7mm Spacers (55) as shown. Do not over-
tighten the Bolt Set; the left Handlebar
Leg
must pivot freely.
Attach the right Handlebar
Leg (not shown)
to the Right Pedal Arm (not shown)
in the
same way.
See step 7. Tighten the four M8 x 38mm Button
Bolts (58).
10
69
92
55
14
10
Advertisement
