Advertisement
iNSTALLiNG
THE RECEIVER FOR THE OPTIONAL
CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor, follow
the steps below to install the receiver included with the
chest pulse sensor.
1.
Remove the cover from the compartment on the
back of the Control Console (75).
Connect the wire on the receiver (A) to the wire in
the console.
/o
75
Console
Wire
Cover
.
.
Remove the paper from the adhesive pad on the
back of the receiver (A). Press the receiver onto
the inside wall of the compartment cover.
A
',
Pad
Cover
Then, reattach the compartment cover to the back
of the Control Console (75).
Note: Any other wires that are included with the
chest pulse sensor may be discarded.
21
Advertisement
