Advertisement
11. While a second person holds the Display
Console (74) and the Control Console (75) near
the Upright (2), connect the wires on the
Console to the Pulse Jumper Wire (76) and to
the Upper Wire (77).
Insert the excess wires into the Upright (2) or
into the Console (74).
Tip: Avoid pinching
the wires. Set the
Consoles (74, 75) on the Upright (2). Attach the
Consoles with seven M4 x 16mm Screws (47).
11
47
76
75
Avoid pinching
the wires
12. Attach the Water Bottle Holder (26) to the
Upright (2) with two M4 x 19mm Screws (57).
12
57
13. Make sure that all parts of the elliptical
are properly
tightened.
Note: Some hardware may be left over
after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical.
11
Advertisement
