Installing Sensor Espio - Sensor Espio Installation And Operation Manual

5

Installing Sensor Espio™

INSTALLATION PRECAUTIONS
Make absolutely sure that Sensor Espio™ is vertical when handled, with the battery compartment
down.
This alarm system is only suited to swimming pools meeting the two following conditions at the
location of the alarm system:
- water depth of 60cm. minimum.
- distance between the underside of the coping and the waterline between 8,5 and 20 cm.
Make sure the swimming pool water is clear and clean before you install your pool alarm.
For bigger distances, use a specific Sensor Espio™ extension.
Ask your retailer for advice.
You are reminded that the French act No 2003-9 dated 3 January 2003 on swimming pool safety
requires that a device be installed permanently throughout the year. Your retailer or MG International
cannot be held liable in the event of drowning after the removal or complete stopping of your alarm
system for whatever reason.
Should you restart your alarm system after a long period, perform the tests described in page 18. In
case of a problem, contact your retailer immediately.
The only authorized operation on the device once it is installed is changing the battery.
Do not use an electric screwdriver when installing your device.
Some robot cleaners of the diving robot type are incompatible with fall detection systems.
The performances as defined in the NF P90-307 French standard is not guaranteed beyond wind
levels greater than those specified in this standard.
During the first 30 minutes after the first activation of Sensor Espio™ with the remote control, you will
be in test mode. For more information see p24.
-5-