Other Functions - Sensor Espio Installation And Operation Manual

24
Test mode
This mode allows you to perform the installation
and monthly tests without disturbing you or the
neighbourhood.
In this mode, the siren sounds only for a short
time and at a low volume.
The test mode lasts for 30 minutes.
The start and stop of the "test mode" are
!
indicated by a specific tune.
This mode is automatically
batteries are installed.
Warning: When you place the magnet on the green light, the device first reacts as described
above in the "USING THE MAGNET" section.
!
You must keep the magnet on the light to have sound validation (indicated by a loud beep) and
flashing of the red indicator light.
OFF mode
You are reminded that the French act No 2003-9 dated 3 January 2003 on swimming pool safety
requires that a device be installed permanently throughout the year. Your retailer or MG International
cannot be held liable in the event of drowning after the removal or complete stopping of your alarm
system for whatever reason.
Be careful, according to the regulation, the pool must be secured all year long. Do not put Sensor
!
Espio™ in off mode unless you have another safety system that complies with the Standard.
In off mode, all Sensor Espio™ indicator lights are off.
To reactivate Sensor Espio™ press the grey button.
!

OTHER FUNCTIONS

activated when
Place the magnet on the green indicator light
until you obtain sound validation (indicated by
a loud beep) and fast flashing of the red
indicator light, then press the grey button on
the remote control for confirmation. The red
indicator
confirmation sound signal (15 short beeps).
-24-
light remains on during the