Using Sensor Espio; Precautions For Use - Sensor Espio Installation And Operation Manual

20

Using Sensor Espio™

PRECAUTIONS FOR USE

The remote control and magnet must imperatively be kept out of the reach of children.
Make absolutely sure that Sensor Espio™ is vertical when handled, with the battery
compartment down.
Certain rough weather conditions (strong winds, storms, etc.) and the use of certain powerful cleaning
equipment can cause untimely alarm triggering.
Your alarm system will not operate if the water in the probe is frozen or the surface of the pool is
frozen. It is hard to know when the water is frozen in the tube. If unsure, check that the alarm works.
When cleaning the outside of your fall detector, do not use any high-pressure cleaning apparatus,
abrasive brush and/or other implements which might scratch or damage your fall detector.
To ensure proper operation of your poll alarm , please keep the water clear and clean at all times (in
particular to avoid the formation of algae inside the probe).
You are reminded that the French act No 2003-9 dated 3 January 2003 on swimming pool safety
requires that a device be installed permanently throughout the year.
Your retailer or MG International cannot be held liable in the event of drowning after the removal or
complete stopping of your alarm system for whatever reason.
Should you restart your alarm system after a long period, perform the tests described page 18. In
case of a problem, contact your retailer immediately.
The only authorized operation on the device once it is installed is changing the battery.
Do not use an electric screwdriver when installing the device.
Regularly check that your Sensor Espio™ is working properly by performing the tests mentioned in
this guide (see page 15 and 33).
Any user who shuts off the system must be aware that surveillance by a person must take over from
the system.
-20-