Sensor Espio Installation And Operation Manual page 13

12
The siren must go off less than 20 seconds
after the fall. Stop the alarm by pressing the
grey button on your remote control.
You must always perform additional fall tests at different locations in the pool
(including steps) following the steps described below:
After simulating a fall, it is necessary to wait the automatic restart of your pool alarm before
!
carrying out a new one. Depending on wind and pool disturbance conditions, this reactivation can
last around 10 minutes.
During those tests your device will exit the "test mode" and you pool alarm' siren will sound at
!
full volume. You can reactivate the "test mode" during 30 minutes (see p24).
If one of these tests fails:
•
Look up page 30 (frequently asked questions)
•
Ask your retailer for advice
!
•
Contact MG International's technical support service : 0891 025 026 (0,22€ /min)
•
Ask your questions to our technical support team by indicating all details to:
infoconso@aquasensor.com
Wait for the automatic restart (green
indicator flashing).
-12-