Sensor Espio Installation And Operation Manual page 20

19
During those tests your device will exit the "test mode" and you pool alarm' siren will sound at
!
full volume. You can reactivate the "test mode" during 30 minutes (see p24).
After a fall or one action from you, Sensor Espio
automatically restart its monitoring after a few minutes. During this time, utmost
!
vigilance must is required from parent/responsible adult.
If one of these tests fails:
•
Look up page 30 (frequently asked questions)
•
Ask your retailer for advice
!
•
Contact MG International's technical support service : 0891 025 026 (0,22€ /min)
•
Ask your questions to our technical support team by indicating all details to:
infoconso@aquasensor.com
Make sure that you are no longer in TESTS mode: the siren must be at full volume (100dB).
You must always perform additional fall tests at different locations in the pool
(including steps); the siren will go off loudly. If you do not stop it manually by moving the magnet
over the swimmer symbol, the siren will sound for 1 minute and 30 seconds and your pool alarm will
be in armed mode.
Check that the alarm can be heard from the residence/living quarters. If such is not the case,
install in the residence/living quarters the optional Sensor Domo™ remote siren available at your
retailer's.
YOUR IMMERSION DETECTOR IS NOW ACTIVATED,
GREEN INDICATOR LIGHT FLASHING.
™
is not monitoring any longer! It will
-19-