Brother PDS-5000 Service Manual page 96

(4) Unlock the lock to disconnect the first side CCD flat cable, and release it from the
securing fixtures.
Note:
• Be sure to replace the double-sided tape with a new one, after taking off the flat
cable from the double-sided tape.
• After disconnecting flat cable, check that the cable is not damaged at its end or
short-circuited.
• When connecting flat cable, do not insert it at an angle. After insertion, check that
the cable is not at an angle.
First side CCD flat cable
Harness routing: Refer to
Fig. 3-68
"1. Main PCB ASSY" and
3-53
"9. First side CCD flat cable".
Confidential