Brother PDS-5000 Service Manual page 72

(3) Unlock the lock to disconnect the LCD PCB flat cable from the LCD PCB ASSY.
Note:
• After disconnecting flat cable, check that the cable is not damaged at its end or
short-circuited.
• When connecting flat cable, do not insert it at an angle. After insertion, check that
the cable is not at an angle.
(4) Remove the two taptite cup B M3x8 screws to remove the LCD PCB ASSY from the
panel ASSY.
Panel ASSY
Harness routing: Refer to
LCD PCB ASSY
Taptite cup B M3x8
Fig. 3-33
"1. Main PCB ASSY" and
3-29
LCD PCB flat cable
"4. LCD PCB ASSY".
Confidential