Planet FSD-504HP User Manual page 11

Cable distance for switch
 If the "DIP Switch Mode" is set to
Note
 If the "DIP Switch Mode" is set to
Make sure the wiring is correct
Category 3/4/5 cable can be used in 10
Mbps operation. To reliably operate your
network at 100Mbps, you must use an un-
shielded twisted-pair (UTP) Category 5/5e
Note
cable, or better data grade cabling. While a
Category 3 or 4 cable may initially seem to
work, it will soon cause data loss.
Step 5: Supply power to the FSD-504HP.
A. Connect one end of the power cable to the
B. Connect the power plug of the power cable
When the Switch receives power, the power LED should
remain solid Orange.
"Standard", then the distance of UTP/
STP cable between the FSD-504HP and
PC/PD devices should not exceed 100
meters.
"Extend", then the cable distance be-
tween the FSD-504HP and PC/PD devices
should not exceed 250 meters.
Switch.
to a standard wall outlet.
- 10 -