Wall Mounting; Connecting The Power Cord - Honeywell SPM Technical Handbook

2.1 Wall Mounting

For proper operation, place the SPM in a stable, level
position protected from accidental bumps or jars. Make
sure the planned installation conforms to the local wiring
or installation regulations.
The SPM accessory kit contains a mounting kit
for securing the unit to a wall. See
information on the Pole Mount Kit.
The wall mounting kit contains four stainless steel
mounting brackets (41), eight flat washers, and eight
screws (40). The brackets can be attached vertically
or horizontally to the back of the enclosure. Use
wall fasteners (not included) appropriate for the wall
material.
To mount the SPM, prepare wall fasteners as indicated
in the illustration. Leave screw heads loose for tightening
after the unit has been positioned. Attach and tighten
the brackets to the threaded inserts (42) on rear face of
the enclosure. Slide the mounts over the screw heads
and then fasten securely to the wall.

2.2 Connecting the Power Cord

The SPM is supplied with an IEC power line connector
that plugs into any standard 120VAC electrical outlet.
When fitted with the Z-Purge option, the SPM will have
an explosion-proof switch and the power line should
be conduit wired. See
Battery Backup/Portable SPMs connect with the battery
Section 5.6
charger; see
To ensure proper operation of your instrument, make
sure it is connected to a grounded power source.
SPM Technical Handbook
Section 5.8
Section 5.2.4 for more details.
for more details.
SPM Single Point Monitor
for
Legend
40. Mounting washers and screws
41. Mounting bracket
42. Threaded inserts
2-2