Dress Plate Mounting - Honeywell NOTIFIER NCD Instruction Manual

Installation

2.5 Dress Plate Mounting

Refer to Figure 2.5 for information on mounting the NCD to the DP-GDIS1 (for row A of the CAB-4 Series Cabinet) or DP-GDIS2 (for
rows B-D of the CAB-4 Series Cabinet).
• Locate the four mounting studs on the dress plate.
• Locate the two ground screw standoffs on the dress plate.
• Line up mounting holes on the NCD with the mounting studs on the dress plate with the screen facing out.
• Secure the NCD to the dress plate using the four #4-40 nuts to fasten the NCD to the dress plate.
• Install Ground Screws on the dress plate using two #6-32 screws.
NOTE: It is important to secure ground screws on both the Core (top) and DIM (bottom) board for proper operation.
NOTE: These two positions
are reserved for ACM style
Annunciators and blank plates.
The NCD should NOT be
mounted here.
Mounting Nuts
16
Ground Screws
Figure 2.5 Dress Plate Mounting
Mounting Stud
NCD Instruction Manual — P/N LS10210-051NF-E:C 2/18/2019
Dress Plate Mounting
Ground Screw Standoff
Mounting Stud