IBM Aptiva Handbook page 64

4.
Type "Y" to select
Yes
changes in CMOS .
You must load the Setup default settings in the following
instances:
W when you replace the system battery
W when you customize your system configuration settings
and some resource assignments conflict causing the
computer to stop responding
&DQFHOOLQJ FKDQJHV
There may be times when you have made changes in the
Setup parameter settings but decided to discard the
changes.
To cancel the changes that you have made, follow these
steps:
1.
Return to the Configuration/Setup Utility menu
2.
Highlight the Exit Without Saving
and . Then press
Enter Y
The Setup program then clears all the changes that
you made and resets the parameters to their previous
settings. These settings are the settings that were in
place when you started Setup.
6-6 Chapter 6: BIOS Setup configuration
, then press to save the
Enter
option then press
again.
Enter
([LWLQJ 6HWXS
When you have finished viewing the settings and making
changes, press Esc to return to the "Configuration/Setup
Utility menu. From this location, you can exit Setup and save
your changes or exit without saving your changes.
To exit Setup without saving the cahnges, follow these steps:
1.
From the Configuration/Setup Utility menu, press the
key.
Esc
2.
A dialog box appears saying "Quit without Saving (Y/
N)? Type Y, and then press Enter.
You also can Exit the Setup by highlighting
the Save & Exit Setup
Note:
option and follow the dialog box
Saving
directions.
To exit setup and save the changes, follow these steps:
1.
From the Configuration/Setup Utility menu, select Save
and Exit Setup. Then, press Enter.
2.
A dialog box appears saying "Save to CMOS and EXIT
(Y/N)?" Type Y, and then press Enter. The computer
restarts using the new settings.
option or
Exit without