IBM Aptiva Handbook page 104

4.
Insert a new 3V lithium battery (CR2032) into the
socket and press it down until the securing clip clicks
and locks the battery in.If you replace the system
Make sure you insert the battery with the
Important: positive side on top. A plus (+) sign indicates
the positive side.
battery, you need to reset the system date and time in
Setup.
Follow these steps:
1.
Enter Setup. See "Entering Setup" on page 6-3.
2.
From the Configuration/Setup Utility menu, select
"Sandard CMOS Setup"
3.
Set the date and the time.
4.
Exit Setup and save the change.
5.
Use the left arrow key to select
save the settings in CMOS.
You can also change the time and date from the Windows 98
desktop.
1.
Double-click on the
2.
Double-click on the
3.
From the Control Panel, double-click on the
icon to display the items for changing the date and
time.
4.
Make the necessary changes then click on the
button.
OK
9-8 Chapter 9: Adding and replacing system board components
.
, then press
Yes
icon.
My Computer
icon.
Control Panel
Date/TIme
When you add system board components, such as system
memory modules, your system's Basic Input/Output System
(BIOS) detects the hardware changes and updates the
CMOS settings automatically. However, if you replace or
remove components, you might receive a message that asks
you to verify if the automatic detection changed the
configuration correctly.
To verify or correct the system configuration settings, enter
Setup. See the section "Entering Setup" on page 6-3.
to
Enter