Table of Contents
Advertisement
TOOLS NEEDED
Pipe Wrench
Hacksaw
Tape
Measure
MATERIALS NEEDED
Pipe Thread Tape
or Sealant, Primer and
PVC Cement
PVC
P ri me r
C emen t
1½" Male Adapter
(slip x MPT)
or
2" Female
Adapter
(slip x FPT)
SECURE CYCLER
For better stability,
New Water Cycler
may be mounted on
a treated wood base
using Phillips pan head
screws, one in front
and two in back. If you
have questions about
stability, please contact
your dealer or King
Technology.
Hard-Plumbed Installation - Model 120
The New Water Cycler should always be installed between
the fi lter and pool (or between heater and pool if applicable).
Never install New Water Cycler before the heater or
damage to the heater could occur.
®
Bi-fl ow valve design allows
Do NOT install New
installation in either fl ow
Water Cycler Model
direction.
120 off-line.
1.
Screw adapters into each end of New Water Cycler following
directions for a male adapter or a female adapter. Hand
tighten. Finish tightening by turning 1 to 2 revolutions with a
pipe wrench. DO NOT OVER TIGHTEN.
®
1a.
If using male adapters, apply
pipe thread tape or sealant to the
threaded end of each adapter.
P ri me r
3.
Following primer directions, brush primer on the inside of the
adapters and to ends of pipe. Repeat this process with PVC
cement following directions on that product.
5.
®
®
®
OR
12"
®
1b.
If using female adapters, apply
pipe thread tape or sealant to the
threaded end of each feeder port.
PVC
C emen t
®
Do NOT install in copper pipe as
chemical corrosion may lead to pipe
failure.
Allow a minimum
of 12" above and
12"
on each side of
New Water Cycler to
ensure room for easy
replacement of New
®
Water Cycler Pac.
12"
Measure the distance
2.
between the outside
adapters and cut out a
section of pipe 3" less
than that dimension.
®
®
4.
Insert PVC pipe into adapters with
a twisting action. Hold in place 5 to
10 seconds to bond.
To prevent damage to heaters or fi lters,
see your dealer about installing a
corrosion resistant check valve which
will reduce the back fl ow of chlorine gas
when the Cycler is turned off.
9
Advertisement
Table of Contents
