Off-Line Installation Model 430 - King Technology New Water Series Instruction Manual

TOOLS NEEDED
Screwdriver
Pipe Wrench
Battery
Operated Drill
with 5/8" or 19/32"
Bit
MATERIALS NEEDED
Pipe Thread
Sealant
Primer and
PVC
P ri me r
PVC Cement
C emen t
OFF-LINE KIT
Included with the
New Water Cycler
Two Male
Adapters
Two Reducer
Bushings
Two 90
Degree Elbows
Four Hose
Clamps
6' of Tubing
Two
Scoops
Two Scoop
Gaskets
Two Scoop Clamps
Off-line Installation - Model 430
®
Do NOT install New Water Cycler
Model 430 in-line as this Cycler
is different than an in-line unit.
1.
C Y C LER
M et er
ed Po ol
Purifier
P ri me r
PVC
C emen t
3.
Following Primer directions,
brush Primer on reducer
bushings and inside of male
adapters. Repeat this process
with PVC cement following
manufacturer's directions on
that product.
SCOOPS
2" – 36" APART
®
®
Bi-fl ow valve design allows installation in either fl ow direction.
Following pipe thread sealant
directions, brush sealant onto
New Water Cycler threads in
both ports and on both male
adapters.
DO NOT USE PIPE THREAD
TAPE as the threads
on these units are
not suitable for
this use and
leaking or fi tting
failure could result.
4.
Insert reducer bushing
into male adapter on both sides
with a twisting action. Hold in
place 5 to 10 seconds to bond.
The New Water Cycler should
always be installed between
the fi lter and pool (or between
heater and pool if applicable).
Never install New Water Cycler
before the heater or damage
to the heater could occur.
OR
®
2.
Screw a male adapter
into each port of New Water
Cycler and hand tighten.
Completely tighten turning
1 to 2 revolutions with
a pipe wrench.
DO NOT
OVER
TIGHTEN.
5.
Following pipe thread sealant
directions, brush sealant onto
elbow threads.
11