Maintenance - Replacing Cap O-Rings And Knobs - King Technology New Water Series Instruction Manual

Cycler Maintenance
continued...
Replacing the Cap O-Ring
Model 120
1.
Remove old O-ring.
Top half of
2.
groove.
Bottom half
of groove.
3.
O-ring in top
4.
of groove
SILICONE
LUBRICANT
Product # 01-22-9970
Replacing Cycler Knobs
Front of Model 120
Place new O-ring in bottom
half of groove.
Place your thumbs on each
side of the cap over the
O-ring in the groove.
Roll your thumbs back and
forth over the O-ring while
pushing upward until the
O-ring falls into the top of
the groove.
Lubricate O-ring every couple of months with silicone lubricant that came with your New Water
Cycler. DO NOT USE petroleum based lubricants.
To replace, simply unscrew old knob and replace with the new one.
Back of Model 120
Models 400/430
1.
Remove old O-ring.
Top half of
2.
groove
Bottom half
of groove
3.
Back of
Model 400/430
Place new O-ring in bottom
half of groove.
Place your thumbs on
each side of the cap over
the O-ring in the groove.
Roll your thumbs back and
forth over the O-ring while
pushing upward until the
O-ring falls into the top of
the groove.
Cap of
Model 400/430
23