Base Flex-Hose Installation Model 120 - King Technology New Water Series Instruction Manual

TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread Tape
or Sealant
Two Hose Adapters
1½" X 1½" X 1¼"
Two Sections of 1½"
or 1¼" Flex Hose (one
provided with fi lter)
Two
Hose
Clamps
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under
chlorination, replace eyeball
fi ttings in the return jets to a
smaller or larger size to adjust
back pressure. For best results
use King Technology's pressure
gauge, order part number
01-22-4000.
8
Base Flex-Hose Installation - Model 120
PUMP
FILTER
Apply pipe thread tape or sealant
1.
to the threaded end of both hose
adapters.
3.
Attach the fi lter section of fl ex hose to one hose adapter
and the return section of fl ex hose to the other hose
adapter with clamps and tighten with screwdriver. Bi-fl ow
valve design allows installation in either fl ow direction.
HOSE
CLAMP
FILTER &
PUMP
To prevent damage to heaters or fi lters, see your dealer
4.
about installing a corrosion resistant check valve which
will reduce the back fl ow of chlorine gas when the Cycler
is turned off.
For better stability, New Water Cycler may be mounted
5.
on a treated wood base using Phillips pan head
screws, one in front and two in back. If you have
questions about stability, please contact your dealer or
King Technology.
The New Water Cycler should always be installed
between the fi lter and pool (or between heater
and pool if applicable). Never install New Water
®
Cycler before the heater or damage to the
heater could occur.
TO POOL
Screw adapters into each end of New Water
2.
Cycler. Hand tighten. Finish tightening by
turning 1 to 2 revolutions with a pipe wrench.
DO NOT OVER TIGHTEN.
1 1/2" 1 1/2" 1 1/4"
X X
HOSE ADAPTER
1 1/2" OR 1 1/4"
FLEX HOSE
HOSE
®
ADAPTER
HOSE
ADAPTER
TO POOL
CHECK
HOSE
VALVE
CLAMP
HOSE
CLAMP
®
®