Table of Contents
Advertisement
Cycler Maintenance
Replacing Control Dial O-Rings
• Model 120
Center of locking pin
1.
2.
3.
Back
o-ring
01-22-9970
4.
5.
22
In the back of the New Water
Cycler depress center of
locking pin with a fi nger and
pull pin out of dial.
Turn control dial back and
forth as you pull it out of the
housing.
Replace both O-rings. Apply
silicone lubricant that came
with your New Water Cycler on
SILICONE
LUBRICANT
O-rings.
Product #
Carefully insert control dial
back into housing.
Replace locking pin by
pushing it through the slots
on the dial until it locks into
place.
• Models 400/430
1.
2.
3.
4.
SILICONE
LUBRICANT
Product #
01-22-9970
5.
6.
7.
Using a needle nose pliers,
fi nd the snap ring tail located
at approximately the 5 o'clock
position under the control dial.
Pull down and out of the groove.
Using a large screwdriver, loosen
the control dial. Carefully pry the
dial until it pulls out.
Carefully replace the rubber O-ring
without stretching it. Apply silicone
lubricant that came with your New
Water Cycler on O-ring.
Push control dial completely into
the housing and turn the dial to
setting 2.
Insert the non-lipped end of snap
ring into the groove opening
beginning at the 5 o'clock position
and push it up so that it threads
itself around the control dial.
Using a small screwdriver or
pointed tool to help guide it, make
sure the snap ring stays in the
groove as it is inserted.
Advertisement
Table of Contents
