Table of Contents
Advertisement
TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread Tape
or Sealant
One 6" x 1½" TBE PVC
Nipple
One Hose Adapter
1½" x 1½" x 1¼"
One Section of
1½" or 1¼" Flex Hose
(provided with fi lter)
One
Hose Clamp
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under
chlorination, replace eyeball
fi ttings in the return jets to a
smaller or larger size to adjust
back pressure. For best results
use King Technology's pressure
gauge, order part number
01-22-4000.
Filter Flex-Hose Installation - Model 120
1.
Apply pipe thread tape or sealant
to each threaded end of nipple.
Apply pipe thread tape or
4.
sealant to threaded end of
hose adapter.
2.
Screw one end of nipple
into the fi lter return.
Hand tighten. Finish tightening
by turning 1 to 2 revolutions
with a pipe wrench.
DO NOT OVER TIGHTEN.
Screw adapter into the other
5.
side of New Water Cycler.
Hand tighten. Finish
tightening by turning
1 to 2 revolutions
with a pipe wrench.
DO NOT OVER TIGHTEN.
®
®
HOSE ADAPTER
3.
Screw either side of New
Water Cycler on to open
nipple end until upright and
secure.
®
6.
Attach return section of hose to
the adapter with clamp. Tighten
clamp with screwdriver.
7.
To prevent damage to heaters
or fi lters, see your dealer about
installing a corrosion resistant
check valve which will reduce the
back fl ow of chlorine gas when
the New Water Cycler is turned off.
®
7
Advertisement
Table of Contents
