Safety Labels On Cycler - King Technology New Water Series Instruction Manual

Safety Label on Cycler
Review this label before installing or operating this Cycler. Contact King Technology at 800-222-0169 if this label is missing from your New Water Cycler.
Fire, explosion and high pressure hazards
To minimize the risk of serious injury, death or property damage while using the New Water Cycler:
a Read, understand and follow all instructions and safety precautions in the manual, and on this Cycler and on any label for
chemicals used with this Cycler including New Water Cycler Pacs.
a Never use fast dissolving chlorine tablets, liquid bleach, or calcium hypochlorite in the New Water Cycler.
a Never mix Trichlor chlorine tablets with Calcium Hypochlorite, or with any other form of concentrated chlorine or other chemicals.
a Never add any other types of chlorine, pH adjusters, shock treatments or algaecides through the skimmer.
These products should be added directly into the pool if required.
a Do not contaminate the New Water Cycler or New Water Cycler Pacs with dirt, organic matter, pool chemicals (such as calcium
hypochlorite or pool shocks), fertilizers or other household chemicals. Contact between any of these substances and the New Water Cycler or
New Water Cycler Pacs, will result in a chemical reaction with the generation of heat, liberation of hazardous gasses and fi re
or explosion.
a Use only New Water Cycler Pacs in the New Water Cycler. Never use bulk chemicals.
a To prevent the build up of gas pressure in the New Water Cycler, be sure the pool return line valves are open –
except when opening or servicing the unit.
a Do not inhale fumes from the New Water Cycler or New Water Cycler Pacs.
a Avoid sparks, smoking, or any open fl ame near New Water Cycler or chemicals.
a Do not exceed maximum operating pressure of 50 psi or maximum temperature of 104 º F.
a Do not remove the cap while under pressure. Always turn off pump and bleed off pressure before opening New Water Cycler.
a Do not install automatic or fast shut off valves downstream of New Water Cycler.
a Always install the New Water Cycler AFTER a heater (if applicable) on the return line.
a Always install any additional sanitizing equipment AFTER and NEVER BEFORE the New Water Cycler is installed on the return line.
a Do not permit children to use or climb on this product. This product must be positioned to prevent children from using it as a
means of access to the pool.
a Always stand clear of the New Water Cycler during pump start-up.
a Replace New Water Cycler if you see signs of cracks, damage or degradation to the Cycler body or cap.
a Prior to pressurizing, check with your dealer to ensure your plumbing connections meet building codes.
a Failure to properly winterize your New Water Cycler could result in freeze damage. (See page 18 for winterizing details.)
DANGER
WARNING
NOTICE NOTICE
5