Table of Contents
Advertisement
6.
Screw elbow into reducer
bushings on both sides.
10.
Attach a gasket to
each scoop.
13.
Tighten scoop clamps
with a screwdriver.
16.
12
7.
Cut tubing
to size for
each New
Water
Cycler
connection
and attach
one to each
elbow with
clamps.
11.
Place scoops inside
holes so the inlet scoop
faces the water fl ow
and the outlet scoop
faces away from the
water fl ow. Scoop
arrows should be
facing each other when
correct.
14.
8.
Tighten clamps
with a screwdriver.
2" – 36" apart on straight pipe
Arrows on scoops must face
each other.
Attach each hose to venturi
scoop male nipple with a
small clamp and tighten with
screwdriver.
SCOOPS
2" – 36" APART
To prevent damage to heaters or fi lters, see your dealer
about installing a corrosion resistant check valve
®
which will reduce the back fl ow of chlorine gas when
the Cycler is turned off.
9.
When pipe is
totally dry, drill two
19/32" or 5/8" holes,
between 2" - 36"
apart, on the return
line. Be careful not to
go through other side
of pipe.
Attach scoop clamps
12.
over the scoops and
around the pipe.
15.
For better stability, New Water
Cycler may be mounted on
a treated wood base using
Phillips pan head screws, one
in front and one in back. If you
have questions about stability,
please contact your dealer or
King Technology.
Advertisement
Table of Contents
