Getting Started - Kontron coolMONSTER/S User Manual

GETTING STARTED

3.
The easiest way to get the coolMONSTER/S board running is to use a PISA baseboard from Kontron
Embedded Modules GmbH. Take the following steps:
1. Turn off the power supply.
2. Connect the power supply to the baseboard or the coolMONSTER.
3. Plug a memory module into the memory socket of the coolMONSTER.
4. Plug the coolMONSTER to the PISA baseboard.
5. Connect the CRT monitor to the CRT interface or a LCD panel to the JIPA interface by using
the corresponding adapter cable.
6. Plug the keyboard to the PS/2 keyboard connector and the mouse to the PS/2 mouse
connector.
7. Connect the floppy drive cable to the coolMONSTER floppy interface. Attach the floppy drive
to the connector at the opposite end of the cable.
8. Connect the power supply to the floppy's power connector.
9. Plug a hard-drive data cable to one of the coolMONSTER hard-disk interfaces. Attach the
hard disk to the connector at the opposite end of the cable.
10. If necessary, connect the power supply to the hard disk's power connector.
11. Make sure all your connections have been made correctly.
12. Turn on power.
13. Enter the BIOS by pressing the F2 key during boot-up. Make all changes in the BIOS setup.
See the BIOS chapter of this manual for details.
Getting Started 6
KONTRON
coolMONSTER/S User's Guide