Safety Instructions - Avaya S8300 Hardware Installation

Audience
The intended audience for the documentation for this product is trained service personnel.
Admonishments
Admonishments used in the documentation for this product have the following meanings:
!
CAUTION:
Indicates the presence of a hazard that will or can cause minor personal injury or property damage if
the hazard is not avoided.
!
WARNING:
Indicates the presence of a hazard that can cause death or severe personal injury if the hazard
is not avoided.
Power Requirements
The G700 Media Gateway uses an auto-ranging 100-240 VAC power supply, 50 to 60 Hz, 5 A maximum at 100-
120 VAC and 3 A maximum at 200-240 VAC. The AC power source is to be single phase, 3-conductor (Line,
Neutral and Ground) with a 15 A circuit breaker for 100-120 VAC or a 10 A circuit breaker for 200-240 VAC.
!
WARNING:
Do not overload the power circuit.
Electrical Hazards
!
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure continued
compliance to international radiated emissions requirements, all captive screws must be
securely tightened such that they cannot be loosened without the use of a tool.
!
WARNING:
The Avaya G700 Media Gateway must not be operated with any slots open. Empty slots should
be covered with the supplied blank plates.
Grounding
!
CAUTION:
System grounding must comply with the general rules for grounding provided in Article 250 of the
National Electrical Code (NEC), National Fire Protection Agency (NFPA) 70, or the applicable
electrical code in the country of installation.
!
WARNING:
If the installation location is greater than 50 feet (15 m) from an approved ground, do not install
the Avaya G700 Media Gateway until a licensed electrician is present to install a
Supplementary Ground Conductor.

Safety Instructions