Removing And Replacing An Lff Hot-Plug Drive; Removing And Replacing An Lff Drive Blank - HPE Apollo z70 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing an LFF hot-plug drive

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
Procedure
1. Back up all server data on the drive.
2. If installed, remove the front bezel.
3. Determine the status of the drive from the drive LED definitions.
4. Remove the drive:
a. Press the latch to open the release lever.
b. Pull the release lever to disengage the drive from the backplane, and then slide the drive out of the bay.
To replace the component, reverse the removal procedure.

Removing and replacing an LFF drive blank

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
28 Removal and replacement procedures