Remote Control; Water-Drainage - ElectrIQ P12C-V2 User Manual

REMOTE CONTROL

The air conditioner can be controlled with the remote
control. Two AAA-batteries are required to use the
remote control.
Note: the air flow direction cannot be adjusted with the
remote control.
POWER : Press the POWER button to turn the
1.
machine on or off.
TIMER : Press the TIMER button to set the
2.
timer.
DOWN : Press the DOWN button to decrease
3.
the desired temperature or timer
MODE : Press the MODE button to switch
4.
between cooling, fan and dehumidifier modes.
UP : Press the UP button to increase the
5.
desired temperature or timer
FAN : Press the FAN button to change
6.
between high and low fan speeds.
SLEEP MODE
7.
turn on the sleep mode

WATER-DRAINAGE

MANUAL DRAINAGE:
1. When the internal water tank is full the unit will stop working and the TANK FULL light will
illuminate.
2. Shut off the unit and unplug. Try not to move the model abruptly as this may cause water
to spill out from internal water tank.
3. Place a tray under the lower drainage port.
4. Remove the water plug from the lower drainage port - water will drain from the container.
5. Put the water plug back once the tank has drained
CONTINUOUS DRAINAGE:
1. Remove the water plug on the lower drainage port
2. Connect a suitable water pipe to the lower drainage port.
3. You can plumb this pipe into your current plumbing system, lead it outside or use a water
pump.
Note: This model has a self-evaporative function, which reduces the need to empty the water
tank. If the unit is vented correctly most of the water is reused to cool the condenser coils
and any excess is evaporated. Please do not use continuous drainage if you intend to use
the self-evaporating facility. In dehumidifier mode you may need to use the continuous
drainage option.
: Press the SLEEP button to
Page 11 of 15