Mounting Fasteners In Base - GLP Highlander Wash Quick Start And Safety Manual

German Light Products

Mounting fasteners in base

See Figure 4. The base of the fixture has two threaded holes A that accept M10 bolts or
machine screws, and four mounting points B that accept standard camlock quarter-
turn fasteners. The camlock center-to-center distance is 90 mm (3.54 in.).
Mounting directly with rigging clamps
To install the Highlander Wash in any orientation on a
rigging truss or similar support:
Obtain two half-coupler type rigging clamps that
are in perfect condition and approved for the
weight of the fixture.
See Figure 5. Pass two M10 grade 8.8 steel bolts or
screws through the two rigging clamps and check
that the bolts will protrude minimum 9 mm / 0.35 in.
and maximum 11 mm / 0.43 in. into the base of the
fixture when tightened.
See Figure 4. Fasten the bolts or screws through the
half-coupler clamps and into holes A in the base of
the fixture so that the clamps are held securely.
Fasten the rigging clamps securely around a rigging truss chord or similar bar.
Secure the fixture against clamp failure following the instructions in 'Securing the
fixture with a safety cable' on page 16.
Make sure that the head will not collide with another fixture or any other object
when it moves through its full pan and tilt ranges.
Mounting with omega brackets and rigging clamps
To suspend the Highlander Wash from a rigging truss or similar structure with the head
hanging downwards using omega brackets and rigging clamps:
Obtain two omega brackets and two rigging clamps that are in perfect condition
and approved for the weight of the fixture.
Highlander Wash Quick Start and Safety Manual
®
B
A
B
Figure 4. Mounting points in base
B
A
B
Figure 5. Min./max. bolt
protrusion into fixture base
(millimeters)
17