Avaya Vantage K100 User Manual page 15

The handset uses a Lithium-Ion battery with the battery management and protection system. The
protection system allows to prevent the following situations:
• Overcharging.
• Over-discharging.
• Charging if the ambient temperature is higher than 40 °C (102 °F).
Note:
During an active call using the speaker, the device does not charge the handset to avoid audio
disruption from the speaker.
Battery recharge time
The battery fully recharges in less than 3 hours. You do not need to fully discharge the battery
before charging.
Battery disposal
At the end of the service life, remove the battery and deliver it to a battery recycling depot. Do not
dispose of the battery in the normal waste stream.
Wireless handset LED indicator
The blue LED indicator shows the current state of the handset and is also used to indicate user
actions.
Wireless handset state
Wireless handset is in the Pairing
mode.
Pairing completed successfully.
Wireless handset is used in a call
Wireless handset is turned on
and is connected to its base
(Connected mode).
Wireless handset is trying to
establish connection to its base
(Linkback mode).
Wireless handset is out of range
and is not trying to establish
connection to its base (Standby
mode).
Incoming call.
Mute.
March 2019
LED indication
LED flashes every 0.5 seconds.
LED flashes 10 times at 0.1
seconds rate.
LED flashes 3 times every 3
seconds
LED flashes 2 times every 5
seconds.
LED flashes every 0.5 seconds.
LED flashes every 5 seconds.
LED flashes 3 times every 7
seconds.
LED is on and flashes 3 times
every 4 seconds.
Using the Avaya Vantage
Comments on this document? infodev@avaya.com
Notes
Wireless handset exits the Pairing
mode in 150 seconds.
None
None
None
None
Wireless handset is turned off
after 22 minutes.
None
None
™
Device
Specifications
Table continues...
15