Pool Cover Specialists INFINITY 4000 Installation Manual page 21

Installation Checklist
Tracks
q All track ends filed. This is extremely important.
q Does the track space measurement match how the cover system was ordered?
q Cover goes through the track joints smoothly.
q All track screws are tight and flush.
q Pulleys are flush against the end of the track.
q The guides are snug against the track.
q Tracks are bolted in and are tight and Stops are installed.
q Splices used when joining the tracks, even in retainer.
Mechanism
q Mechanism installed level in the box.
q Roll-up Tube level in housing.
q Roll-up Tube centered between the tracks.
q Enough clearance top, bottom, sides for the fabric. No rubbing of webbing on sides or bottom of box.
q Tube at the right height?
q System mounted at right angle to the track.
q Ropes coming back straight out of the track. An excessive angle will cause wear on the cover guides at the end of the track.
q Ropes are not rubbing on any brackets or the deck.
q Ropes are run correctly.
q 8 feet of rope left on rope reel.
q System bonded according to electrical code. Cover bonded to leading edge and roll-up tube.
q Rope loops installed on or near each lid bracket so rope cannot droop and snag on cover or lid brackets.
q Make sure there is adequate drainage from the cover housing.
Cover
q Fabric pinned to the roll-up tube without pinned folds.
q Cover runs smoothly.
q Cover properly aligned when it closes or retracts. Note: An inch or two out of square is not uncommon and is not a
concern as it will not affect the operation of the cover. Because of the size of the fabric roll and changes in operating
conditions the cover may vary slightly in alignment as it is run.
q The leading edge inserts move in and out freely the whole length of the pool.
q Cover does not rub in the housing as it rolls up.
Cover Lid
q All sharp edges have been filed.
q All areas where the lid is not flat on the deck have been screwed down to eliminate any potential hazards.
q There is enough clearance between the lid brackets and the cover to avoid rubbing.
Misc.
q Key switch is in full view of the pool.
q Cover pump tested by putting it in the water and operate it in front of homeowner.
q The cover box is clean and clear of debris so that the drains are not easily clogged.
q Pool area cleaned up.
q Homeowner has been instructed.
© Latham Pool Products, Inc. 2019. All rights reserved.
21 of 21
L0400 3.15.19 bm