Routing The Ropes; Track Retainer; Magnet Installation - Pool Cover Specialists INFINITY 4000 Installation Manual

Step By Step Instructions
10
Insert and tap the locking strip into place
underneath the track along the entire
length of the track. Make sure a locking strip
is placed at all track spices. Do this along
both sides of the pool. The shim needs to
end at the inside edge of the cover box.
13
On the non-motor end, run the rope around
the pulley and out the backside of the pulley
assembly. Pull this rope along the back of the
cover box to the motor end pulley assembly.
Be sure to route the rope in front of the lid
brackets.
16
Drill through the center of the retainer and
track using a 1/4" drill bit.
© Latham Pool Products, Inc. 2019. All rights reserved.
11

Routing the Ropes

Begin on the motor end of the mechanism.
Run the rope from the track so it travels
straight from the track to the first pulley.
Extend the rope out the back side of the
pulley.
14
Insert the rope from the non-motor end into
the channel behind the first pulley on the
motor end. This rope will travel behind all
three pulleys and come out alongside the
third pulley. Pull the rope toward the rope
reel.
17
Insert the locking ring pin (25) through the
retainer and the track. This will lock the track
into the retainer so it can't slide into the
cover box as the cover system is operating.
13 of 21
Numbers in parenthesis refer to parts shown on page 3
12
This rope will continue from the first pulley to
the second pulley. Pull the rope so it comes
out alongside the second pulley.
15

Track Retainer

With retainer installed on the pool, and
extended one inch into the cover box, it is
used to keep the track from being pulled
into the cover box.
18

Magnet Installation

Test the polarity of the 7/16 x 6" autostop sensor
magnet (31) by running it past the sensor while
the motor is running in the uncover position.
When the motor successfully shuts off from the
magnet passing the sensor, the side of the
magnet facing up will need to be inserted into
the webbing in that same orientation. This may
need to be reversed if the sensor needs to be
mounted under the guide.
wn