Adjusting The Ropes - Pool Cover Specialists INFINITY 4000 Installation Manual

Step By Step Instructions
40 46
With the cover in the fully closed position,
mark the webbing where it is in line with
the sensor that is mounted on the guide.
49
Insert a screw driver through the slit in the
webbing to create the pocket for the magnet.
52

Adjusting the Ropes

When opening the cover, if both sides of the
cover don't open squarely, one of the ropes
may need to be adjusted. To adjust the
rope, open the cover all the way. Pull the
excess rope off the rope reel. Pull on the
rope that will adjust the side of the cover
that is closest to the cover box so it will be
straight with the other side of the cover.
© Latham Pool Products, Inc. 2019. All rights reserved.
47
Measure back 6-1/2 inches from the mark that
was made on the webbing.
50
Apply the supplied grease to the magnet.
This will help it slide in the webbing
easier. Insert the magnet (31) through the
slit in the webbing. Push it forward until it
is completely inside the webbing and in
line with the mark on the webbing.
53
If one of the ropes is longer than the other
rope, lift the tabs that secure the ropes to
the rope reel. Shorten this rope, by inserting
more rope into the opening in the reel.
Secure the rope by pushing back down on
the tab.
17 of 21
Numbers in parenthesis refer to parts shown on page 3.
48
Using a utility knife, carefully cut a slit in
the webbing long enough for the magnet
to be slid through. Be careful not to cut
through the bottom layer of webbing.
51
Run the key switch in the uncover position
to roll the cover up on the roll-up tube.
Check the cover to be sure it rolls up evenly.
Run the cover 6-10 times to make sure it
opens and closes evenly. The cover fabric
installation is now complete.
54
If both ropes are the same length, and the
cover doesn't close squarely, shorten the
rope for the side of the cover that doesn't
close all the way. The amount that the rope
is shortened is equal to the distance that the
cover needed to travel to close all the way.
After shortening the rope, run the switch in
the cover position while holding the ropes.