Table of Contents
Advertisement
User Manual | Imperea
Programmable Options
Configure these optional settings via the SDK.
Charging Current
Charging current may be set to 500mA (default) or 1000mA.
Set Charging
The Imperea can charge the iPhone using its internal battery by enabling the "setCharging" setting. When the Imperea battery is above 20%, it will then start
to charge the iOS device battery.
Enable Scan Button
Select the Enable Scan button in the SDK.
Scan Mode
Imperea supports the following scan modes:
Single Scan
Scanning a single barcode by pressing and releasing either Scan button.
Multi Scan
Scanning multiple barcodes by pressing and holding either Scan button.
Motion-Detect
Scanner is activated automatically when barcode is placed near the barcode engine.
Multi-Scan without Duplicates
Scanning multiple barcodes without duplicates.
Pass-Through Sync
When enabled and the USB Type-A cable is plugged in, the iOS device is synced with a Windows computer or an Apple MacOS.
When syncing is required, enable the Pass-Through Sync setting in the SDK. When this setting is disabled and the USB cable is plugged in, the Imperea only
charges, but does not scan.
To use the scanner again, the USB Type-A cable must be removed.
Idle Time
Default setting: 5400 seconds (90 minutes).
11
Advertisement
Table of Contents
Need help?
Do you have a question about the Imperea and is the answer not in the manual?
Questions and answers