Thermal Metrology
Figure 5-9.
Detailed Thermocouple Bead Placement
10. Place the device under the microscope to continue with the process.
11. Using tweezers or a finger, slightly press the wire down inside the groove for about
5 mm from tip and place small piece of Kapton* tape to hold the wire inside the
groove. Refer to
Figure 5-10. Tapes Installation
12. Thermocouple bead is placed into the bottom of the groove (Refer to
and a small piece of tape is installed to secure it under the microscope to perform
this task.
Intel® 3210 and 3200 Chipset Thermal/Mechanical Design Guide
Figure
5-10.
Figure
5-11)
25