Mounting And Installation Procedure - GE QuickPanel+ IC755CxS06RDx User Manual

5.4

Mounting and Installation Procedure

Observe the following guidelines to properly mount and install the QuickPanel
Note To order replacement gaskets, refer to the part number listed in
• The enclosure should be of metal material.
• The metal enclosure panel should ensure proper thickness and rigidity suitable to minimize impact to the QuickPanel
unit.
• The recommended torque for the plastic back cover and interior metal cover for the 10, 12, and 15" QuickPanel
display units that is accessed for panel updates and serial port DIP Switches is 0.5 Nm (4.4 in-lb).
• To avoid gasket degradation, limit repeated insertions or removals of the unit and retightening of the mounting
clips. For full protection, always use a fresh gasket.
• The unit will not fit through the cutout with any cables connected, or with the power supply plug inserted in the
socket.
Caution
➢ To install the QuickPanel
1. Cut an opening in the panel according to the specifications in the following figures.
Note Panel cutout tolerances are +0.50, –0.00 mm (+0.02, –0.00 in).
Panel Thickness:
1.0 to 5.0 mm
(0.04 to 0.20 in)
IC755CxSO6RDx or IC755CxW07CDx
Panel Cutout Dimensions
Panel Thickness:
1.6 to 5.0 mm
(0.06 to 0.20 in)
IC755CxS12CDx Panel Cutout Dimensions
66 GFK-2847W
For public disclosure
When installing the QuickPanel
handling the unit so it does not drop and damage the unit.
+
183.50 mm (7.22 in)
302 mm ( 11.89 in)
Operator Interface:
+
Appendix B.
into the panel, pay careful attention while
+
Panel Thickness:
1.6 to 5.0 mm
(0.06 to 0.20 in)
IC755CxS10CDx Panel Cutout Dimensions
Panel Thickness:
1.6 to 5.0 mm
(0.06 to 0.20 in)
IC755CxS15CDx Panel Cutout Dimensions
QuickPanel⁺ Operator Interface User
Manual
+
266 mm (10.47 in)
379 mm (14.92 in)
+