GE QuickPanel+ IC755CxS06RDx User Manual page 110

3. Adjust the position of the retaining clamp by pushing the lever of the retaining clamp. Then close the retaining
clamp to fit the cable size.
Warning
Government Regulations
The FCC requires the following note to be published according to FCC guidelines:
Note This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Changes or modifications to this unit that are not expressly approved by GE Intelligent Platforms could void the
user's authority to operate the equipment.
Industry Canada requires the following note to be published:
Note This Class A digital apparatus complies with Canadian CAN ICES 3 (A)/NMB 3(A).
GFK-2847W
For public disclosure
EXPLOSION HAZARD — Do not connect or disconnect equipment power,
communication, audio, or battery unless power has been removed or the area
is known to be non-hazardous.
EXPLOSION HAZARD — Substitution of components may impair suitability.
EXPLOSION HAZARD — DO NOT VESA MOUNT. Panel mount only with enclosures
that shall only be opened with the use of a tool in an area where the risk of impact
is low
DO NOT MAKE ANY CONNECTIONS TO THE MINI-USB/MIC TERMINAL AS IT WILL
INVALIDATE THE ATEX APPROVAL.
QuickPanel⁺ Operator Interface User
Manual