Assembly & Disassembly Procedure - GE Bently Nevada 3300/03 Operation Manual

3300/03 System Monitor Operation Manual
3. ASSEMBLY & DISASSEMBLY PROCEDURE
This section explains how to disassemble the System Monitor to set jumper options on the circuit
board. To install a System Monitor to a rack set the options as described in section 7 then do
steps 1 through 4 in reverse order. The only tool you need is a screwdriver.
1. Loosen the screws
on the front panel and
pull the System Monitor
out from the rack.
CAUTION
Improper rack operation may
occur.
Power down rack when intalling
or removing a monitor.
2. Remove the side cover by
pinching the protruding tip
on each of the 4 standoffs.
4