Configure Trap Destinations - GE QuickPanel+ IC755CxS06RDx User Manual

The following sections provide the procedures to enable and configure the QuickPanel
Agent and establish communication with a SNMP Manager.
•

Configure Trap Destinations

• Enable or Disable SNMP Agent
• Export MIB to SD Card
• Load MIB into SNMP Manager
• Data Types Mapping between PME Project and SNMP
• Establish SNMP Communication
3.14.1 Configure Trap Destinations
TRAP Destinations are configured through the QuickPanel
to which Traps should be sent. The user can configure two different Trap Destinations (IP Addresses).
Note If you do not want to be notified of Traps, you do not need to configure Trap Destinations.
➢ To configure Trap Destinations
Attention
1. From the Start menu, select System, open the QuickPanel
2. Configure the Trap destination(s) of the SNMP Manager.
3. Click OK to save the changes.
Close the QuickPanel Setup Tool, then re-open the tool to view the configured Trap Destination details from the
+
SNMP Agent tab.
Software
For public disclosure
+
If Trap Destination(s) is/are configured after enabling the SNMP Agent on the device,
it is highly recommended that you disable and then re-enable the SNMP Agent
service on the device.
Setup Tool by providing the IP Address of the SNMP Manager
Setup Tool, and select the SNMP Agent tab.
+
Enter the IP Address(es) of the SNMP Manager to which
Traps should be sent.
device to operate as a SNMP
+
GFK-2847W 49